Where Are First Layer Settings?

[LannyDana]

I just need to print the first layer a little slower. Where is the setting to do that in the UPStudio software?

[SirLucian]

I explain how to edit material settings on this thread. That should help you out.

UP MINI 2 - Raft separation problem (fused to part)

Hi, try this, founded on this forum: "* Ensure Dense value is 4 or more. 3 usually works, but 4 always works; definitely don’t use 2 or 1! Why does increasing the “dense” value make the raft easier to remove? The Dense value controls what I call the interface layer; the material between the raft itself and the part. If this is too thin/value too low, then the part fuses with the raft." Hope,that helps, it was ok for me.