Extrusion Multiplier

Can we get acces to an extrusion multiplier in the Cetus software. I have noticed some over/under extrusion with certian materials. When the extrusion rate is set correctly I am more than happy with the results of the prints. (Except when the software decides it needs to add additional support when support is disabled...)


i have a PLA that prints better with 0.2 Nozzel setting eventho i'm using 0.4 as with the 0.4 setting i'm getting heavy overextrusion.

i really which i would be able to fine tune this parameter to get better results with different PLAs.

changing temperature didnt help.