Extruder Stepper isn't rotating correctly

Hi there,

I recieved a printer a while ago.

I was printing using Cetus software, everything was nice and easy.

Actually, the prints came out flawlessly!

But once in a while I’ve seen that the stepper motor int the extruder isn’t rotating correctly, it’s wobbling from side-to-side.

Tried everything - that is possible.



<p>do you mean it is chopping or skipping steps? If so there are several reasons for, filament, temperature, or a blocked nozzle. I realize this sometimes if my z-axis calibration is too low that the filament can not get out of the nozzle while printing the first layer.</p>