Cetus Column Cap for Cable Management

Cetus Cetus 1st Gen MK1-MK3
1

I have two MK3 and one MK2 Cetus. I want the print head cable to extend over the top of the column next to the PTF tube holder. Usually the print head cable flops to the left at the tie point and comes around the side of the column.

I have designed two printed caps to accomplish this cable management. A long version for the MK3 with its end switch and a shorter cap for the MK2 with no end switch.

IMG_0229
IMG_02293024×4032 3.01 MB
IMG_0228
IMG_02283024×4032 3.51 MB
cetus_clip
cetus_clip1024×768 111 KB

1 Like
2

nice job! didn´t try it because my mk2 is already upgraded to end switches but I want to mention that the aluminium profile of the mk2 is longer than the mk3 one… so the belt end cap may be to low or too high.