Bed balance with cura Gcode

Software Using Gcodes
1

I am using the latest CURA but It seems to have problems with the bed bala
I am using the latest CURA but It seems to have problems with the bed balance .
Can anyone advice about bed leveling with CURA for Cetus MKIII?
With the up software its easy inside the bed balance but how do I do it with CURA GCODE

Thanks

Can anyone advice about bed leveling with CURA for Cetus MKIII?
With the up software its easy inside the bed balance but how do I do it with CURA GCODE

Thanks

2

Cura does not compensate for bed, and usually they just adjust mechanically. In MK3 you can use paper as space/washer on bottom to adjust the bed.

3

Tnx
but i have almost 2 m gap so the bed balance dosent help even with the up
can you advice

InkedWhatsApp Image 2020-12-25 at 6.55.34 AM_LI
InkedWhatsApp Image 2020-12-25 at 6.55.34 AM_LI898×1599 151 KB
WhatsApp Image 2020-12-25 at 6.56.09 AM
WhatsApp Image 2020-12-25 at 6.56.09 AM899×1599 139 KB

4

Hello,

You can try add some spacer under the front side of the bed to level the bed.
Then use the compensate in the software to make fine adjustments.

5

I received a pre production Cetus at the time and put a rubber block under the platform, I then used the screws to level it.

See this post: https://www.instagram.com/p/BLoeiGUjjZ3/

6

@shayy

Did you try it? I hope it is resolved.